Characteristics of V - type Wire - wound Screen

Product Overview: filter screen really do outside the circle is very round, without water chestnut, to ensure that the use of scraper cleaning screen, the gap evenly. The minimum gap is 15 microns. The minimum width is 0.45mm.
Application areas: oil, paper, chemicals, natural gas, food, sugar, starch, beer, water treatment, wells sand control and other industries.
Features: 1, no clogging: screen section of the cross-section of the wire is triangular, the screen on the gap is two adjacent to the two sharp angle formed on the surface, solid through the screen when the gap with the two The formation of point contact, so theoretically, the solid particles on the screen is either trapped on the screen, or through the screen gap, can not form a third plug state. This is very important to reduce the running resistance of the equipment, maintain good hydraulic distribution characteristics, and enhance the backwash effect of the resin.
2, high strength: Because this element uses a stainless steel wire around the welding structure, so it has a high strength, this screen can be cut in the wheel cutting machine, can also be machined in the lathe end without causing loose Deformation.
3, the flow of large: This screen has a relatively small resistance, and the size of similar plastic filter compared to greatly increase its flow area, so in the same resistance, the flow of traffic increased significantly. In other words, in the case of the same output, the amount of water filter used can be reduced accordingly.
4, the adaptability of temperature changes: Obviously compared with the ordinary plastic filter, the company's stainless steel wire around the screen temperature range of application than the plastic filter to be much wider.
5, adjustable gap: different users, the use of different filtration equipment and filter media, the wire around the screen around the wire gap requirements are different. As the screen is in the special equipment on the continuous welding around, so the gap between the stainless steel trapezoidal wire can be adjusted. In this way, you can not increase the cost of the premise to meet the needs of different users, and plastic filter to adjust the gap must be re-making mold, so it is not easy to meet the special needs of users. The minimum gap can reach 20 microns.
6, corrosion resistance: for neutral water, acidic water, alkaline water, renewable agent caustic soda, hydrochloric acid, sulfuric acid, salt, etc., as long as the rational use of these materials, you can economically and safely run all kinds of filtration equipment.